Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation


Toyota 4Раннер
- 1. Maintenance instruction
   1.2. Dashboard
   1.3. The combined devices
   1.4. Designation of symbols of light indexes
   1.5. Keys
   1.6. Immobilizer system (recognition of a code of start-up of the engine)
   + 1.7. Doors
   1.8. Cover of a fuel tank
   1.9. Adjustment of a forward seat
   1.10. Adjustment of an inclination of a steering wheel
   1.11. Adjustment of provision of a rear-view mirror
   1.12. Plafond of internal lighting
   1.13. Plafond of individual lighting
   1.14. Cleaner and windscreen washer
   1.15. Cleaner and washer of back glass
   + 1.16. Headlights and turn indexes
   1.17. Heater of back glass
   1.18. Index of a stock of fuel
   1.19. The remote thermometer of cooling means
   1.20. Measuring instrument of pressure of oil
   1.21. Voltmeter
   1.22. Tachometer
   1.23. Counter of the general run and counter of daily run
   + 1.24. Indexes and warning signals
   1.25. Lock of ignition and lock of a steering column
   1.26. Automatic box
   1.27. Radio receiver AM-UKV with electronic control
   1.28. An AM-VHF-radio tape recorder with electronic control
   1.29. Adjustment of the direction of a stream of air
   1.30. Governing bodies heater
   1.31. Hours
   1.32. Lighter and ashtray
   1.33. Perchatochny box
   1.34. The container for trifles
   + 1.35. Actions at refusal of start-up of the engine
   1.36. Identification numbers of the car
   1.37. Identification number
   1.38. Manufacturer's certificate of origin
   1.39. VECI label
   1.40. Numbers on transmission units
   1.41. Car raising jack
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes


Join the community of satisfied users who rely on 123movies.

1.27. Radio receiver AM-UKV with electronic control

Using radio receiver

PERFORMANCE ORDER
1. Turn on the receiver, having turned the PWR.VOL handle clockwise.
2. Adjust loudness further turning the PWR.VOL handle.
3. Be adjusted on the necessary station (see below subitem 1-10 and subitem 1-6).
4. For reception of VHF (FM) - radio stations be switched to a mode of reception of VHF (FM), choose a mode of a stereo or monophonic reception.
5. If transfer on VHF stereo is accepted, the receiver will automatically be switched to stereo reception, at the same time on the display there will be a ST symbol.
6. If a signal weak, be switched to a monophonic mode, having pressed the corresponding button. On the display there will be a MONO symbol.
7. Adjust a timbre and balance (see below).
8. To switch off the receiver, turn the PWR.VOL handle against an hour hand.

Control for station

PERFORMANCE ORDER
1. For a choice mono or stereoreception press the L.M/U button. On the display there will be L.MW or UKW symbols.
2. Be adjusted on the necessary station by means of one of offered below ways. On the display there will be a value of frequency of control.
Control in a program mode
3. Press the button of a choice of station which was in advance brought in memory. The receiver will automatically be adjusted on this station, and on the display button number (see below) will be displayed.
4. Mode of continuous search. In this mode there is a station search. After station reception control automatically stops.
5. Press at the same time on both parties of the TUNE button and wait a continuous sound signal.
6. The receiver will start to carry out automatically search of the next station with higher or lower frequency of a broadcasting.
7. After a consistent reception control stops.
8. By the subsequent pressing of the button search will proceed to a consistent reception of the following station.
9. If because of too weak signal it is not possible to be adjusted after single scanning of all range of frequencies, search will proceed, but at hypersensibility, and on the display there will be a symbol of DX.
Manual control
10. Press at the same time on both parties of the TUNE button of for a while not exceeding 0,5 seconds. By each pressing of the button occurs перескок to frequency on which the broadcasting is possible.

Control programming

PERFORMANCE ORDER
1. Be adjusted on the necessary station (see above).
2. Press the button of a choice of station and wait a sound signal.
3. Thus the station will automatically join by pressing this button, which number will appear on the display.
4. On each button it is possible to remember one AM-station and one VHF station.
5. To bring in memory control for new station repeat the procedure described above.
6. Control for the programmed station is erased at food shutdown (a detachment of the battery, a safety lock peregoraniya etc.).

ARI station reception (road information)

PERFORMANCE ORDER
1. Press the L.M/U button. On the display there will be an UKW symbol.
2. Press the VF button. The receiver will be switched to a mode of reception of ARI, on the display there will be a VF symbol.
3. Be adjusted on the necessary station broadcasting ARI information (see fig. above). After control for ARI station on the display there will be a SK symbol.
4. For ARI broadcasting cancellation repeatedly press the VF button.

Timbre control

It is provided with TONE handle turn.

Balance control

PERFORMANCE ORDER
Pull on itself the PWR.VOL handle and turn.