Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation

Toyota 4Раннер
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
- 5. Fuel and exhaust systems
   5.1. Specifications
   5.2. Order of a decompression of fuel system
   + 5.3. Fuel pump and pressure of fuel
   5.4. Hoses and connections
   5.5. Fuel tank
   5.6. Fuel pump
   5.7. Fuel level sensor
   5.8. Air filter
   5.9. Butterfly valve cable
   + 5.10. System of electronic injection of fuel (EFI system)
   + 5.11. Units of system of injection of fuel
   5.12. Service of an exhaust system
   + 5.13. System of decrease in toxicity of exhaust gases
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes

5.9. Butterfly valve cable


1. Disconnect the battery from weight.
2. Release lock-nuts of a tip of a cable on the zaslonka case.
3. Turn the lever of a butterfly valve and get a cable, having passed it through a groove in the lever.
4. Disconnect a cable from a pedal (are specified by shooters). Unscrew two bolts of fastening of an arm of a cover of a cable to a partition of a motor compartment.
5. Working from within salon, stretch a cable through a partition of a motor compartment.


1. Installation is carried out upside-down.
2. Check correctness of installation of rubber sealants in a wall of a motor compartment.


1. For adjustment of a cable press to the full a pedal, thus the butterfly valve should be completely open. If the zaslonka did not open completely, release lock-nuts, press a pedal to the full and tighten lock-nuts so that the zaslonka was completely open.
2. Check adjustment. At a pedal otpuskaniye the zaslonka should be closed completely.