| 1. Disconnect the battery from weight. |
| 2. Remove door facing. |
| 3. Designate and disconnect all sockets, remove from a door plaits of wires. |
| 4. Completely open a door and prop up a block or a support. |
| 5. Outline contours of loops on a body. |
|
|
| 6. Unscrew bolts (at the left – top, on the right – bottom) loops on a body (the assistant should hold a door) and remove a door. |
| 7. Installation is carried out upside-down. |
| 8. Combine loops with their outlines. |
|
9. If after assembly the door is closed leaky, slightly release screws (are specified by shooters) and adjust the provision of a clamp, having achieved dense closing of a door. |