Toyota 4Раннер
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
- 4. Systems of heating, ventilation
4.1. Specifications
4.2. Antifreeze
4.3. Thermostat
4.4. Krylchatka of the fan and hydrocoupling
4.5. Radiator and tank
4.6. Maslookhladitel
+ 4.7. Pump
4.8. Sensor of temperature of liquid
4.9. Electric motor and chain of the fan of a heater
4.10. Heater radiator
4.11. Control panel conditioning block
+ 4.12. Central air
4.13. Compressor
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes
|
The location of the sensor of temperature on 4-cylinder engines
|
|
1. Temperature sensor
2. Sensor of pressure of oil |
The temperature sensor on the engine of V6 3,0 l
|
|
1. Temperature sensor
2. Sensor of pressure of oil |
The temperature sensor on the engine of V6 3,4 l
|
|
1. Temperature sensor
2. Sensor of pressure of oil |
Check
| PERFORMANCE ORDER |
| 1. If the index does not register temperature, check safety locks. |
| 2. If the sensor shows "Hot" condition ("hot") right after start-up of the cold engine, disconnect a wire from the sensor. If the indication falls, the sensor replace. If the indication remains overestimated, the reasons can be short circuit on mass of a wire of the sensor, or malfunction of the index. |
| 3. If the sensor ceases to show temperature after complete warming up of the engine (about 10 minutes later after start-up), and safety locks are serviceable, arrive as follows. Stop the engine, disconnect a wire from the sensor and a piece of a wire close a sensor wire on well cleared site of the engine. Include for short time ignition but the engine do not start. If the index shows now "Hot", the sensor replace. |
| 4. If indications of the sensor are absent, break in a chain (see subsection 11.18), or malfunction of the index can be the reason. |
|
Replacement
| PERFORMANCE ORDER |
| 1. Disconnect a wire from the sensor. |
| 2. Screw the sensor and turn new, reliably tighten. Attach a wire. |
| 3. Believe liquid level. |
|
|
|