Toyota 4Раннер
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
+ 3.1. 4-cylinder engines
+ 3.2. Engines of V6 3,0 l (1993-1994) and 3,4 l (since 1995)
- 3.3. Dismantle and major maintenance of the engine
3.3.1. Specifications
+ 3.3.2. Major maintenance
3.3.3. Engine diagnostics by means of the vacuum gage
3.3.4. Compression check in engine cylinders
+ 3.3.5. Dismantle of the power unit
- 3.3.6. Head of cylinders
3.3.6.1. Dismantling of a head of cylinders
3.3.6.2. Cleaning and check of a head of cylinders
3.3.6.3. Assembly
3.3.7. Valves
3.3.8. Shatunno-porshnevaya group
+ 3.3.9. Crankshaft
3.3.10. Block of cylinders
3.3.11. Honningovaniye of cylinders
+ 3.3.12. Rods and pistons
3.3.13. Radical and shatunny bearings
3.3.14. Balansirnye shaft
3.3.15. Assembly order
3.3.16. Piston rings
3.3.17. Engine start-up after repair and a running in
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes
|
Prevention
Acquisition of a new head of the block, than dismantling, check and repair of the head which were in operation is represented to more expedient.
Sorting out of details of the klapanny mechanism
|
|
The removed details should be stored in an order of their installation. |
For dismantling of a head of the block of cylinders it is necessary to remove valves and accompanying details. At the description it is supposed that cam-shafts and pushers are already removed
(see subsection 3.1.7 or subsection 3.2.10).
| PERFORMANCE ORDER |
|
|
|
| 1. Compress a spring of the first valve by means of the suitable adaptation (a photo at the left) and take crackers (a photo on the right). Carefully release a valve spring, remove a plate of a spring, a spring and a basic washer (if is available). |
Prevention
At compression of springs do not scratch or do not damage internal openings under pushers.
|
| |
2. Get the valve and remove a maslosjemny cap. |
| 3. Repeat the same actions for other valves. |
|
|
|