| 1. Disconnect a cable from draft (see subsection 5.9). |
| 2. Release a cable from collars in a motor compartment. |
| 3. Unscrew a bolt of a collar of a cable on a hydrotransformer case. |
| 4. Remove the pallet. |
|
5. On A340F/A340E transmissions отверниет 3 bolts also remove solenoidal valves. |
|
|
| 6. Remove tubes, on transmission А43 they can be got, having hooked a screw-driver then it is necessary to unscrew 5 screws of the filter of rough cleaning (drawing at the left). For removal of tubes on transmission А340Е подденте their screw-driver (drawing on the right). |
|
7. In transmission А340F there is only 1 tube. For removal подденте a tube a screw-driver. |
|
8. Remove the filter of rough cleaning of transmission (if it is provided). |
| 9. Unscrew 17 bolts and remove the case of valves (cм. fig. Bolts of the case of valves of transmission А43D and fig. Bolts of the case of valves of transmission А34О). At assembly of the case of valves of transmission of A43D it is necessary to wrap bolts which have different length, in compliance with the scheme. At assembly of the case of valves of transmission of A430 it is necessary to wrap bolts in compliance with the scheme. Before an otvorachivaniye of the last bolt hold the case with the assistant. |
|
10. Lower the case and disconnect a cable from a cam. |
|
|
| 11. Get a cable from transmission. On transmission А43 вытолкните a cable of 10 mm – a face head (drawing at the left). On transmission А340 unscrew a bolt and get a cable (drawing on the right). |
| 12. Pass a new cable. On transmission А340 tighten a bolt. |
| 13. Attach a cable to a cam. |
|
|
| 14. Before installation of the case of valves combine a flute on the valve of a manual drive with a pin on the lever (in drawing transmission А43 at the left is shown, in drawing on the right – transmission А340). |
|
15. Bend a cable so that the radius of curvature was about 200 mm. Push a cable to feeling of weakness in resistance and расклепайте the limiter at distance of 0,8-1,5 mm from an end face of a cover of a cable. |
|
16. Further assembly is carried out upside-down. If necessary adjust a cable.
|