Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation

Toyota 4Раннер
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
- 6. Transmissions
   + 6.1. Mechanical transmission
   - 6.2. Automatic transmission
      6.2.1. Specifications
      6.2.2. Transmission diagnostics
      6.2.3. Cable of a drive of a zaslonka
      6.2.4. Draft of transmission
      6.2.5. The blocking switch
      6.2.6. System of fixing of transfers
      6.2.7. Lever of change of transfers
      6.2.8. Removal and transmission installation
   + 6.3. Transfer case
+ 7. Transmission elements
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes

6.2.8. Removal and transmission installation


1. Disconnect the battery from weight.
2. Get щуп the index of level of liquid.
3. Disconnect a butterfly valve cable for what weaken adjusting nuts, deduce a cable from an arm and unhook from draft. Disconnect cable latches.
4. Remove average section.
5. On 4WD cars remove the lever of a transfer case for what get a lock ring.
6. Lift the car.
7. Remove the bottom guards disturbing to removal of a box.
8. Merge transmission liquid, establish the pallet into place.
9. Unscrew bolts of an arm and remove a branch pipe of the index of level of liquid.
10. Disconnect semi-axes (see subsection 7.8).
11. Remove a forward exhaust pipe.
12. Unscrew a corrugated cap nut and get a speedometer cable. Not допускеайте weakening of felt laying and washers.
13. Disconnect from transmission all sockets (the sensor of speed, the solenoid of the blocking, the blocking switch, etc.).
14. Disconnect a rod from the lever on transmission.
15. Disconnect from transmission the tubes conducting to a cooler.
16. Remove a starter and take wires aside.
17. On cars with the engine 5VZ-FE remove a cross-piece of the stabilizer of a suspension bracket.
18. Uncover the hydrotransformer.
19. Designate position of the hydrotransformer on a leading disk, unscrew serially 6 bolts for what turn the crankshaft clockwise.
20. Establish under a case a jack (it is desirable the special cart). Unscrew bolts of fastening of a shaft of a case to a cross-piece (to a photo at the left). Unscrew bolts, raise transmission and take a cross-piece (a photo on the right).
21. Substitute under the engine a jack and unscrew bolts of fastening of transmission to the engine.
22. Displace transmission back and remove from directing pins. Fix the hydrotransformer on transmission.
23. On 4WD cars remove a transfer case.


1. Be convinced that the nave of the hydrotransformer is in gearing with the pump.
2. Establish transmission on the cart and carefully lift, keeping its horizontal situation. Attach tubes of cooling of liquid.
3. Turn the hydrotransformer and combine the labels put before removal.
4. Carefully submit transmission to the engine and establish on directing pins.
5. Wrap bolts of fastening of transmission and tighten with the set moment.
6. Tighten bolts of fastening of the hydrotransformer.
7. Establish a cross-piece and tighten bolts and nuts.
8. Lower a case shaft, having combined with openings in a cross-piece, tighten bolts and nuts.
9. Further assembly is carried out upside-down (see fig. Automatic transmission (A340 type) of all-wheel drive cars).