Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation

Toyota 4Раннер
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
- 7. Transmission elements
   7.1. Specifications
   + 7.2. Coupling
   + 7.3. Kardanny (е) shaft (ы) and kardanny hinges
   7.4. Back and forward axes
   7.5. Bearing, epiploon and semi-axis of the back bridge
   7.6. Epiploon of a reducer of the back bridge and forward axis
   7.7. Zadny Bridge
   7.8. Forward semi-axes
   7.9. Replacement of covers and CV JOINT dismantling
   + 7.10. Electromagnetic drive of a forward leading axis (ADD system)
   7.11. Forward reducer
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes

7.5. Bearing, epiploon and semi-axis of the back bridge

Removal and installation

PERFORMANCE ORDER

1. Lift the car.
2. Remove the ABS system sensor (if it is provided).
3. Remove a back brake (see subsection 8.6).
4. Disconnect a cable of the hand brake and a tube from the wheel cylinder.
	5. Unscrew nuts of a board of a brake (are specified by shooters).
	6. Carefully get a semi-axis assembled.
	7. Get laying from a bridge flange.
	8. Get an epiploon, having hooked a screw-driver.
9. Replacement of the bearing of a semi-axis is carried out in car-care center.
10. Accurately press a new epiploon by means of an opravka, having greased edges.
11. Establish new laying.
12. Carefully establish a semi-axis.
13. Further assembly is carried out upside-down.