Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation


Toyota 4Раннер
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
- 7. Transmission elements
   7.1. Specifications
   + 7.2. Coupling
   + 7.3. Kardanny (е) shaft (ы) and kardanny hinges
   7.4. Back and forward axes
   7.5. Bearing, epiploon and semi-axis of the back bridge
   7.6. Epiploon of a reducer of the back bridge and forward axis
   7.7. Zadny Bridge
   7.8. Forward semi-axes
   7.9. Replacement of covers and CV JOINT dismantling
   + 7.10. Electromagnetic drive of a forward leading axis (ADD system)
   7.11. Forward reducer
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes




7.6. Epiploon of a reducer of the back bridge and forward axis

Replacement

PERFORMANCE ORDER
1. Lift the car and remove back (forward) wheels.
2. Disconnect from a reducer the driveshaft and displace aside.
3. Check the moment of resistance of a provorachivaniye of a wheel, rotating a reducer nut a dinamometrichesky key with a scale in some N of m.
4. Designate the provision of the nut conducting gear wheels and a flange.
5. Count number of strings of a carving to a nut.
6. Fix a flange of a reducer and unscrew a nut of a leading gear wheel.
7. Remove a reducer flange.
8. Hook and remove an epiploon.
9. Grease an epiploon and a pro-point in a reducer case with konsistentny greasing. Accurately, without allowing shift of a leading gear wheel of a reducer, press a new epiploon against the stop.
10. Establish a reducer flange, having combined labels. To establish a flange in blows it is not allowed.
11. Accurately cover a joint of a flange and шлицов with hermetic.
12. Dress a washer and tighten a nut on the number of threads of a carving counted before dismantling.
13. Measure a torque at which the leading gear wheel starts to be turned. This moment is equal to a preliminary tightness in bearings of a leading gear wheel and should correspond to norm. If the moment appears less demanded, tighten a reducer nut until then the necessary moment (there can be a little more norm but no more than 0,5 N of m) will not be reached yet.
14. Further assembly is carried out upside-down.