| 1. Lift a back part of the car. |
| 2. Establish supports under a bridge beam. |
| 3. Pass through spring rounds a chain and fix a bolt to exclude casual loss of a spring when lowering bridge. The length of a chain should provide complete straightening of a spring. |
| 4. Remove stabilizer collars. |
| 5. Disconnect from the bridge a cross-section bar. |
| 6. Carefully lower the bridge so that it was possible to get springs. Watch a brake hose not to tear off it. |
| 7. Installation of springs is carried out upside-down. |
| 8. Track correctness of installation of springs in the bottom cup. |