Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation


Toyota 4Раннер
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
- 9. Suspension bracket and steering
   9.1. Specifications
   9.2. Springs and shock-absorbers (racks) of a forward suspension bracket
   9.3. Stabilizer of a forward suspension bracket
   9.4. Rotary fist
   9.5. Forward nave and bearing
   9.6. Spherical support
   9.7. Top lever
   9.8. Bottom lever
   9.9. Back shock-absorbers
   9.10. Back stabilizer of cross-section stability
   9.11. Cross-section bar of the back bridge
   9.12. Back springs
   9.13. Longitudinal bars of the back bridge
   9.14. Steering wheel
   9.15. Tip of steering drafts
   9.16. Cover of the steering mechanism
   9.17. Steering mechanism
   9.18. Pump of the hydraulic booster
   9.19. Power steering
   9.20. Corners of installation of forward wheels
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes




9.17. Steering mechanism

Removal and installation

PERFORMANCE ORDER
Prevention

On the cars equipped with a safety cushion rotation of a wheel after removal of the mechanism it is not allowed in order to avoid pillow damage. Fix a wheel, having dressed on it a seat belt and having fixed a buckle.
1. Expose a wheel in the provision of driving on a straight line, lift a car front.
2. Disconnect tips of drafts from fists.
3. Unscrew 10 bolts and remove the bottom guard of the engine.
4. Remove the stabilizer.
5. Designate the provision of an intermediate shaft and unscrew a coupling bolt of the shlitsevy coupling of the kardanny hinge (shooters specified bolts of the coupling of the hinge and the union of tubes).
6. Disconnect from the steering mechanism of a tube of the hydraulic booster.
7. Unscrew a nut and a bolt on the right side of the mechanism, a nut and a through bolt from other party (shooters specified nuts and bolts of fastening of the steering mechanism to a frame).
8. Remove the steering mechanism.
9. If the wheel shaft casually turned, remove a wheel and center the coil of a wire of a safety cushion.
10. Further assembly is carried out upside-down.
11. Tighten bolts and nuts with the set moment and remove air from the hydraulic booster.