Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation


Toyota 4Раннер
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
- 9. Suspension bracket and steering
   9.1. Specifications
   9.2. Springs and shock-absorbers (racks) of a forward suspension bracket
   9.3. Stabilizer of a forward suspension bracket
   9.4. Rotary fist
   9.5. Forward nave and bearing
   9.6. Spherical support
   9.7. Top lever
   9.8. Bottom lever
   9.9. Back shock-absorbers
   9.10. Back stabilizer of cross-section stability
   9.11. Cross-section bar of the back bridge
   9.12. Back springs
   9.13. Longitudinal bars of the back bridge
   9.14. Steering wheel
   9.15. Tip of steering drafts
   9.16. Cover of the steering mechanism
   9.17. Steering mechanism
   9.18. Pump of the hydraulic booster
   9.19. Power steering
   9.20. Corners of installation of forward wheels
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes




9.14. Steering wheel

Removal and installation

PERFORMANCE ORDER
Prevention

The part of cars is equipped with a safety cushion which is in the container in the center of a steering wheel. To exclude casual operation of system the switch of ignition transfer to the situation Lock, disconnect from the battery from weight and wait for not less than 2 minutes.
1. Expose a wheel in the provision of driving on a straight line and disconnect the battery from weight.
2. Disconnect the container with a safety cushion (if it is provided) (see subsection 11.44).
3. Hook and remove the caps located sideways on a wheel.
4. Unscrew screws (with a krestovy head) container fastenings with a safety cushion. Turn out screws so that the flute of the screw came into an edge of an obechayka. A reversing of screws at once stop.
5. Raise the case.
6. Take away a latch and get the safety cushion socket.
7. Disconnect all sockets. which can prevent wheel removal (for example, the socket of a sound signal).
8. Unscrew a nut and designate the provision of a wheel concerning a shaft.
9. Press a stripper a steering wheel. It is forbidden to remove a wheel in blows on a nave.
Prevention

After removal of a wheel it is forbidden to turn a shaft (or wheels) as centering of a spiral wire and a wire will be broken will break, because of what the safety cushion at failure will not work. At casual violation restore centering before wheel installation.
10. Check centering of a spiral wire of a pillow.
11. Be for this purpose convinced that wheels are exposed in situation on a straight line and turn the coil case counter-clockwise against the stop and turn on clockwise on 3 turns, having combined labels.
12. Installation of a wheel is carried out upside-down.
13. Combine labels and tighten a nut with the set moment.