| 1. Lift a front of the car and remove wheels. |
|
2. Remove the sensor of speed (the arrow specified a bolt). |
| 3. Remove a brake support. |
| 4. Remove a brake disk. |
|
|
| 5. Remove a brake board (at the left – bolts of a board of a brake on rear-wheel cars, on the right – bolts of a board of a brake on all-wheel drive cars). |
| 6. Disconnect from a fist a tip of steering draft. |
|
7. Rasshplintuyte also release a koronchaty nut (not to turn on), then by means of a stripper выпрессуйте a finger of a spherical support from the top lever. |
|
8. Rasshplintuyte also release a koronchaty nut (not to turn on) the bottom support (it is specified by an arrow). |
|
9. By means of a stripper выпрессуйте a finger of the bottom support. |
| 10. Disconnect a fist from levers of a suspension bracket and remove. |
| 11. Assembly is carried out upside-down. |