Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation

Toyota 4Раннер
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   - 3.1. 4-cylinder engines
      3.1.1. Specifications
      3.1.2. Types of repair, выполняемыe without removal of the engine from the car
      3.1.3. Installation of the piston of the 1st cylinder in VMT of a step of compression
      3.1.4. Cover of a head of cylinders
      3.1.5. A soaking-up collector
      3.1.6. Final collector
      3.1.7. Cam-shafts and pushers
      3.1.8. Head of cylinders
      3.1.9. Cover of a chain drive of cam-shafts
      3.1.10. Forward epiploon of the crankshaft
      3.1.11. Oil pallet
      3.1.12. Oil pump
      3.1.13. Flywheel (a leading disk of the hydrotransformer)
      3.1.14. Back epiploon of the crankshaft
      3.1.15. Engine mount details
   + 3.2. Engines of V6 3,0 l (1993-1994) and 3,4 l (since 1995)
   + 3.3. Dismantle and major maintenance of the engine
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes

3.1.4. Cover of a head of cylinders


1. Disconnect the battery from weight (be convinced that radio tape recorder codes are known).
2. Remove an air inlet, disconnect from a cover hoses of ventilation of a case.
3. Remove caps of candles, disconnect wires.
4. Disconnect cables and take aside. Remove a hook for engine posting.
5. Unscrew bolts of a cover of a head of cylinders (are specified by shooters), uncover also laying. If the cover does not give in, displace it in hammer blows through a soft pro-rate, or carefully open consolidation by a shpatel.


1. Carefully clear condensed surfaces of a cover and a head of cylinders, remove oil traces. Establish new laying in a cover flute (laying can be not changed if it did not harden and on it there are no damages). Track safety of sealants of casings of candles (are specified by shooters).
2. Put hermetic on semicircular caps and establish them on a head of cylinders.
3. Carefully establish a cover and wrap bolts.
4. Evenly tighten cover bolts with the set moment.
5. Establish other details, start the engine and be convinced of lack of a leak.