Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation

Toyota 4Раннер
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   - 3.1. 4-cylinder engines
      3.1.1. Specifications
      3.1.2. Types of repair, выполняемыe without removal of the engine from the car
      3.1.3. Installation of the piston of the 1st cylinder in VMT of a step of compression
      3.1.4. Cover of a head of cylinders
      3.1.5. A soaking-up collector
      3.1.6. Final collector
      3.1.7. Cam-shafts and pushers
      3.1.8. Head of cylinders
      3.1.9. Cover of a chain drive of cam-shafts
      3.1.10. Forward epiploon of the crankshaft
      3.1.11. Oil pallet
      3.1.12. Oil pump
      3.1.13. Flywheel (a leading disk of the hydrotransformer)
      3.1.14. Back epiploon of the crankshaft
      3.1.15. Engine mount details
   + 3.2. Engines of V6 3,0 l (1993-1994) and 3,4 l (since 1995)
   + 3.3. Dismantle and major maintenance of the engine
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes

3.1.5. A soaking-up collector

GENERAL INFORMATION

Prevention

If the collector is disconnected only for removal of a head of cylinders, unscrew bolts and take him aside, without disconnecting hoses and wires. Procedure of dismantle of a collector from the engine as separate detail below is described.

Cнятие and installation

PERFORMANCE ORDER

1. Disconnect the battery from weight.
2. Execute a decompression of fuel system (see subsection 5.2).
3. Designate and disconnect hoses (see subsection 5.4), a cable of a drive of a butterfly valve (see subsection 5.9) and remove the zaslonka case (see subsection 5.11.1) and the leveling chamber (see subsection 5.11.5).
4. Remove a comb of the distributor of fuel and a nozzle (see subsection 5.11.4).
5. Designate and disconnect valve hoses from a retsirkulyatsiya and from the modulating vacuum valve. Unscrew from a collector a retsirkulyatsiya tube.
	6. Disconnect from a collector a wire on weight, unscrew bolts and nuts (are specified by shooters) remove a collector (previously be convinced that the tube of a return gasoline pipe line is disconnected from a head of cylinders).
7. Clear a collector, check a condition of the demountable plane, if necessary прошлифуйте.
8. Establish new laying, establish a collector and wrap bolts and nuts.
9. Tighten bolts and nuts evenly, with the set moment, being displaced from the center to the periphery.
10. Establish other details upside-down.
11. Before start of the engine check smoothness of turn of a butterfly valve.
12. Start the engine and be convinced of lack of a leak of cooling liquid and tightness of vacuum connections.
13. Check the car in road conditions.