Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation



Toyota 4Раннер
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
- 11. Electric equipment
   11.1. Specifications
   11.2. Battery
   + 11.3. Ignition system
   11.4. Coil (and) ignitions
   11.5. Ignition distributor
   11.6. Check and installation of the moment of ignition
   11.7. Block of electronic ignition
   11.8. Induction sensor
   + 11.9. System of a charge of the battery
   + 11.10. Generator
   11.11. System of start-up of the engine
   + 11.12. Starter electric motor
   11.13. Traction relay
   11.14. Tension check
   11.15. Detection of short circuit
   11.16. Check of reliability of grounding
   11.17. Check of integrity of a chain
   11.18. Finding of not closed chain
   11.19. Search of malfunctions
   11.20. Safety locks
   11.21. Fusible crossing points
   11.22. Breakers
   11.23. Relay
   11.24. Breaker of indexes of turn / alarm system
   11.25. Switch of indexes of turn
   11.26. Lock of ignition and lock drum
   11.27. Switch of external lighting
   11.28. Screen wiper switch
   11.29. Lamps of headlights
   11.30. Adjustment of headlights
   11.31. Headlight case
   11.32. Replacement of lamps
   11.33. Receiver and loudspeakers
   11.34. Aerial
   + 11.35. Screen wiper electric motor
   11.36. Switch of heating of back glass
   11.37. Heater of back glass
   11.38. Guard of devices
   11.39. Sound signal
   11.40. Electric drive of mirrors
   11.41. Cruise control
   + 11.42. Window regulator electric drive
   11.43. Electric drive of door locks
   11.44. Safety cushions
+ 12. Electroschemes




11.30. Adjustment of headlights

GENERAL INFORMATION

Prevention

It is necessary to check adjustment of headlights each 12 months, at replacement of a headlight or after repair of a forward part of a body. It should be noted that described procedure allows to adjust approximately only headlights, exact adjustment is carried out in car-care center.


Adjusting screws of a headlight

1. Screw of horizontal adjustment

2. Screw of vertical adjustment

Scheme of adjustment of headlights

1. The line at distance from a floor to the center of headlights

2. Area of a light spot

3. The line at distance from an axis of symmetry of the car to the center of headlights

4. Distance of 7,5 m

5. Forward plane of a headlight

6. Axis of symmetry of the car

PERFORMANCE ORDER
1. On the case of a headlight 2 screws for adjustment in the vertical and horizontal planes (see fig. are provided. Adjusting screws of a headlight).
2. Establish the car in 7,5 m from a wall.
3. Designate a tape a perekrestiya of symmetrically axis of the car (see fig. Scheme of adjustment of headlights). For more exact marking approach on a wall on distance about 20 see.
4. Adjustment is carried out at normal loading of the car and a thin tank.
5. Establish a bunch of a passing beam of headlights so that the light spot settled down on 5 cm below a horizontal and on 5 cm the vertical is more right. For lifting of a bunch rotate the screw clockwise and on the contrary. The same concerns adjustment to the left – to the right.
6. Include a driving beam of headlights and adjust a bunch so that the spot was strictly on the vertical line, directly under a horizontal.

Prevention

Precisely to expose bunches of a driving and passing beam in such a way it can appear impossible. In this case try to adjust more precisely a passing beam with which it is necessary to go more often and on which traffic safety more depends.


7. As soon as possible adjust headlights in car-care center.