Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation


Toyota 4Раннер
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
- 7. Transmission elements
   7.1. Specifications
   + 7.2. Coupling
   - 7.3. Kardanny (е) shaft (ы) and kardanny hinges
      7.3.1. Check of driveshafts
      7.3.2. Removal and driveshaft installation
      7.3.3. Replacement of kardanny hinges
   7.4. Back and forward axes
   7.5. Bearing, epiploon and semi-axis of the back bridge
   7.6. Epiploon of a reducer of the back bridge and forward axis
   7.7. Zadny Bridge
   7.8. Forward semi-axes
   7.9. Replacement of covers and CV JOINT dismantling
   + 7.10. Electromagnetic drive of a forward leading axis (ADD system)
   7.11. Forward reducer
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes




7.3.3. Replacement of kardanny hinges
PERFORMANCE ORDER
1. Remove the driveshaft.
2. On a part of cars type hinges "double кардан" which are not subject to repair are established. The driveshaft assembled in this case changes.
3. Clamp a shaft in a vice, designate the provision of forks of the hinge and get lock rings.
Prevention

Lock rings of bearings of hinges can be located in external or in an internal part of the needle bearing of a crosspiece. In the first case the ring is taken пассатижами, in the second – by knocking-out from a flute in a bearing glass.
4. Vypressuyte bearing glass. For this purpose establish a crosspiece in a vice via the plug on the one hand and through an opravka with another. Compress a vice until then while the glass of the bearing will not appear at the edge of a fork.
5. An alligator wrench or flat-nose pliers get a bearing glass.
6. Rearrange an opravka and the plug and выпрессуйте an opposite glass.
7. Carefully clear a fork.
8. Establish a crosspiece and insert a glass into a fork. Soriyentiruyte a crosspiece so that the direction of a butterdish coincided with the butterdish direction on the opposite end of a shaft (if butterdishes are provided).
9. Insert a crosspiece into the bearing, insert the opposite bearing. Carefully, without having damaged epiploons, press bearings, having combined them with crosspiece necks.
10. Establish rings. If necessary пристукните in strong blow on a fork that rings became in a place. If rings do not come into flutes, disassemble the hinge and check freedom of rotation of bearings on crosspiece necks.
11. Establish a shaft. Grease crosspieces (if there are butterdishes).



QX4.ONLINE
S40.ONLINE
A-8.ONLINE
W124.ONLINE
RX300.ONLINE
W140.ONLINE
B3-B4.SPACE
B3B4.SPACE
A-8.SPACE