Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation



Toyota 4Раннер
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
- 8. Brake system
   8.1. Specifications
   8.2. ABS system
   8.3. Blocks of disk brakes
   8.4. Brake support
   8.5. Brake disk
   8.6. Blocks of drum-type brakes
   8.7. Wheel cylinder of back brakes
   8.8. Main cylinder of brakes
   8.9. Hoses and hydraulic actuator tubes
   8.10. Pressure regulator
   8.11. Hand brake
   8.12. Cables of the hand brake
   8.13. Vacuum amplifier of brakes
   8.14. Pumping of brakes
   8.15. Adjustment of a pedal of a brake
   8.16. Switch of a signal of braking
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes



8.12. Cables of the hand brake

GENERAL INFORMATION

Cable arm on a bridge beam

The cable arm on a bridge beam – is specified by an arrow.

Cable arms on a frame

Cable arms on a frame – are specified by shooters.

Bracket of fastening of a cable

The bracket of fastening of a cable – is specified by an arrow.

Replacement

PERFORMANCE ORDER
1. Release the hand brake. Lift the car and remove wheels.
2. Weaken a cable, having unscrewed a nut.
3. Disconnect a cable from a regulator crank.
5. The cable is established upside-down. Adjust the hand brake.
4. Get a cable from arms, get brackets.
5. The cable is established upside-down. Adjust the hand brake.