Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation


Toyota 4Раннер
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
- 8. Brake system
   8.1. Specifications
   8.2. ABS system
   8.3. Blocks of disk brakes
   8.4. Brake support
   8.5. Brake disk
   8.6. Blocks of drum-type brakes
   8.7. Wheel cylinder of back brakes
   8.8. Main cylinder of brakes
   8.9. Hoses and hydraulic actuator tubes
   8.10. Pressure regulator
   8.11. Hand brake
   8.12. Cables of the hand brake
   8.13. Vacuum amplifier of brakes
   8.14. Pumping of brakes
   8.15. Adjustment of a pedal of a brake
   8.16. Switch of a signal of braking
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes




8.9. Hoses and hydraulic actuator tubes
GENERAL INFORMATION

The condition of hoses and tubes is recommended to check each 6 months.

Bracket of fastening of the union

 1. Tube

2. Bracket

3. Hose

Check and replacement
PERFORMANCE ORDER
1. Clear the union of dirt.
2. Turn out the tube union from a hose and get a bracket. Disconnect a hose from a support and remove.
3. Installation is carried out upside-down. At installation of a hose replace copper laying of the ring union. Arrange a hose so that it did not touch suspension bracket and steering details (the car at assembly not to lift). Remove air from a hydraulic actuator.
4. At replacement of tubes track, that on all route they were fixed by collars.
5. Installation of only steel tubes, in accuracy corresponding to make of the car is allowed.