Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation

Toyota 4Раннер
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
- 8. Brake system
   8.1. Specifications
   8.2. ABS system
   8.3. Blocks of disk brakes
   8.4. Brake support
   8.5. Brake disk
   8.6. Blocks of drum-type brakes
   8.7. Wheel cylinder of back brakes
   8.8. Main cylinder of brakes
   8.9. Hoses and hydraulic actuator tubes
   8.10. Pressure regulator
   8.11. Hand brake
   8.12. Cables of the hand brake
   8.13. Vacuum amplifier of brakes
   8.14. Pumping of brakes
   8.15. Adjustment of a pedal of a brake
   8.16. Switch of a signal of braking
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes

8.4. Brake support



At serious damages it is recommended to replace a support.


1. Release nuts of wheels, lift the car and establish on supports. Remove wheels.
2. Remove about 2/3 liquids from a tank (to exclude transfusion at cultivation of blocks). Clear a support and adjacent details.
3. If the support changes, unscrew a nut of the union of a hydraulic actuator (bolts of the union are specified by shooters).
4. Unscrew bolts and remove a support. If in a disk the fillet because of development was formed, previously remove blocks.
5. Replace a support at detection of traces of a leak.
6. Assembly is carried out upside-down. Bolts of a support tighten with the set moment. Remove air from a hydraulic actuator (if understood).