Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation


Toyota 4Раннер
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
- 8. Brake system
   8.1. Specifications
   8.2. ABS system
   8.3. Blocks of disk brakes
   8.4. Brake support
   8.5. Brake disk
   8.6. Blocks of drum-type brakes
   8.7. Wheel cylinder of back brakes
   8.8. Main cylinder of brakes
   8.9. Hoses and hydraulic actuator tubes
   8.10. Pressure regulator
   8.11. Hand brake
   8.12. Cables of the hand brake
   8.13. Vacuum amplifier of brakes
   8.14. Pumping of brakes
   8.15. Adjustment of a pedal of a brake
   8.16. Switch of a signal of braking
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes




8.5. Brake disk
GENERAL INFORMATION
Prevention

Blocks change only in a set on one axis. When cleaning blocks a dust and dirt to delete with wiping by rags moistened in alcohol or special liquid, it is forbidden to blow.

Check and removal

PERFORMANCE ORDER
1. Release nuts of wheels, lift the car and establish on supports. Remove wheels and wrap nuts of wheels into place to fix a disk concerning a nave (to provide the annex of effort to a disk it is possible to dress washers).
2. Remove a support and take aside.
3. Check a disk condition from both parties. At detection of traces of deep development (depth more than 0,38 mm) remove a disk and прошлифуйте. At detection of traces from rivets of overlays for disk surfaces as it is specified in drawing – a disk replace.
4. Check palpation by means of the strelochny indicator. If palpation on the indicator exceeds norm, remove a disk and прошлифуйте.
Prevention

The disk in general is recommended to be removed and ground periodically on it is dependent on indicator indications. At least it can be made by hand a small skin to reduce a roughness.
5. After polishing the thickness of a disk should not be less maximum permissible which is cast on a disk.
6. After checks unscrew wheel nuts and remove a disk.

Installation

Establish a disk and collect a brake upside-down. Lower the car.