Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation

Toyota 4Раннер
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
- 8. Brake system
   8.1. Specifications
   8.2. ABS system
   8.3. Blocks of disk brakes
   8.4. Brake support
   8.5. Brake disk
   8.6. Blocks of drum-type brakes
   8.7. Wheel cylinder of back brakes
   8.8. Main cylinder of brakes
   8.9. Hoses and hydraulic actuator tubes
   8.10. Pressure regulator
   8.11. Hand brake
   8.12. Cables of the hand brake
   8.13. Vacuum amplifier of brakes
   8.14. Pumping of brakes
   8.15. Adjustment of a pedal of a brake
   8.16. Switch of a signal of braking
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes

8.16. Switch of a signal of braking

GENERAL INFORMATION

Switch of a signal of braking

The switch and position of the switch are specified by shooters.

Check and replacement

PERFORMANCE ORDER

1. The switch is over a brake pedal.

2. If the switch does not close contacts, check a safety lock and lamps of a signal of braking.

3. If these details are serviceable, check tension presence on the switch.

4. If tension is absent, check wires. Otherwise be convinced that by pressing a pedal on the second contact there is a tension. If tension is not present, the switch replace. If tension appears, but lamps do not burn, check a chain from the switch to lamps.

5. For replacement remove the bottom facing of a steering column, disconnect from the wire switch, unscrew a lock-nut and remove the switch.

6. Establish the switch upside-down. Adjust the switch.