Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation


Toyota 4Раннер
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
- 8. Brake system
   8.1. Specifications
   8.2. ABS system
   8.3. Blocks of disk brakes
   8.4. Brake support
   8.5. Brake disk
   8.6. Blocks of drum-type brakes
   8.7. Wheel cylinder of back brakes
   8.8. Main cylinder of brakes
   8.9. Hoses and hydraulic actuator tubes
   8.10. Pressure regulator
   8.11. Hand brake
   8.12. Cables of the hand brake
   8.13. Vacuum amplifier of brakes
   8.14. Pumping of brakes
   8.15. Adjustment of a pedal of a brake
   8.16. Switch of a signal of braking
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes




8.15. Adjustment of a pedal of a brake
GENERAL INFORMATION

Height of a pedal of a brake

1. Switch of a signal of braking


2. Pusher


3. Pedal height

PERFORMANCE ORDER
1. Check pedal distance from a floor.
2. In need of adjustment disconnect the socket, unscrew a lock-nut and remove the switch of a signal of braking.
3. Release a lock-nut of a pusher of the amplifier of brakes.
4. Rotating a pusher, adjust pedal height. Tighten a lock-nut.
5. Establish the switch of a signal of braking and adjust. For this purpose unscrew the top nut so that the plunzher of the switch adjoined to the pedal limiter. Wrap the top nut on 1 turn and check A.Pri neobkhodimosti's gap establish a standard gap and tighten a lock-nut. Attach the socket.
6. Check fire of lamps of a signal of braking.
7. Check a free wheeling of a pedal (1 – a pusher, 2 – a free wheeling of a pedal), i.e. distance from the provision of completely released pedal to a place in which resistance to its course starts to be felt. If the course does not correspond to norm, repeat switch adjustment.
8. Check height (and) the pressed pedal on the working engine.
9. If the height of the pressed pedal does not correspond to norm, brakes are faulty (there is a leak).