Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation


Toyota 4Раннер
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
- 8. Brake system
   8.1. Specifications
   8.2. ABS system
   8.3. Blocks of disk brakes
   8.4. Brake support
   8.5. Brake disk
   8.6. Blocks of drum-type brakes
   8.7. Wheel cylinder of back brakes
   8.8. Main cylinder of brakes
   8.9. Hoses and hydraulic actuator tubes
   8.10. Pressure regulator
   8.11. Hand brake
   8.12. Cables of the hand brake
   8.13. Vacuum amplifier of brakes
   8.14. Pumping of brakes
   8.15. Adjustment of a pedal of a brake
   8.16. Switch of a signal of braking
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes




8.3. Blocks of disk brakes
GENERAL INFORMATION
Prevention

Blocks change only in a set on one axis. When cleaning blocks a dust and dirt to delete with wiping by rags moistened in alcohol or special liquid, it is forbidden to blow.

PERFORMANCE ORDER
1. Release nuts of wheels, lift the car and establish on supports. Remove wheels.
2. Remove with a sprintsovka about 2/3 liquids from a tank (to exclude transfusion at cultivation of blocks). Clear a support and adjacent details.
3. At removal of blocks be guided by enclosed photos. Remove each block separately.
4. Clear details ториоза.
5. Get the bottom finger of a block.
6. Remove a spring of blocks.
7. Get the top finger and remove an external block.
8. Drown pistons of the external cylinder.
9. Grease with antinoise structure a block basis.
10. Establish antinoise slips.
11. Grease slips with antinoise structure, establish a block, repeat all actions for an internal block and collect a brake upside-down.
12. When dismantling check a condition of covers of cylinders, a support and a disk, check existence of traces of a leak of liquid. In the presence of damages or a leak a support replace. If necessary remove a disk and прошлифуйте.
13. After assembly fill a tank and press several times a brake pedal.