Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation


Toyota 4Раннер
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
- 7. Transmission elements
   7.1. Specifications
   - 7.2. Coupling
      7.2.1. Main cylinder of coupling
      7.2.2. Working cylinder of coupling
      7.2.3. Coupling details
      7.2.4. Vyzhimna bearing
      7.2.5. The directing bearing
      7.2.6. Coupling hydraulic actuator
      7.2.7. Coupling pedal
      7.2.8. The blocking switch of coupling
   + 7.3. Kardanny (е) shaft (ы) and kardanny hinges
   7.4. Back and forward axes
   7.5. Bearing, epiploon and semi-axis of the back bridge
   7.6. Epiploon of a reducer of the back bridge and forward axis
   7.7. Zadny Bridge
   7.8. Forward semi-axes
   7.9. Replacement of covers and CV JOINT dismantling
   + 7.10. Electromagnetic drive of a forward leading axis (ADD system)
   7.11. Forward reducer
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes




7.2.4. Vyzhimna bearing

Removal, check and installation

PERFORMANCE ORDER
1. Remove the working cylinder.
2. Remove transmission.
3. Get a spring bracket from a spherical support of a fork.
4. Remember as fastening of the vyzhimny bearing to a fork looks, take the bearing (a photo at the left). Take a fork (a photo on the right).
5. Check a condition of a dust cover and a spring bracket. At detection of signs of wear replace these details.
6. The bearing should rotate freely, otherwise the bearing replace.
Prevention

To wash out the bearing in solvent it is forbidden.
7. Before assembly grease with refractory greasing of dredging under a spherical support of a fork, under a pusher of the working cylinder and a place of fastening of the bearing.
8. Establish a spring bracket (a photo at the left) and grease with refractory greasing the bearing plug (a photo on the right).
9. Establish the bearing on a fork.
10. Dress the bearing on a check point shaft. Pass a fork through a cover, grease a support and dress a fork on a support, having pressed on it before click (a photo at the left). Check freedom of moving of the bearing on shlitsa of a shaft of a check point (a photo on the right).
11. Slightly grease with refractory greasing a persistent surface of the bearing.
12. Further assembly is carried out upside-down.