Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation

Toyota 4Раннер
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
- 7. Transmission elements
   7.1. Specifications
   - 7.2. Coupling
      7.2.1. Main cylinder of coupling
      7.2.2. Working cylinder of coupling
      7.2.3. Coupling details
      7.2.4. Vyzhimna bearing
      7.2.5. The directing bearing
      7.2.6. Coupling hydraulic actuator
      7.2.7. Coupling pedal
      7.2.8. The blocking switch of coupling
   + 7.3. Kardanny (е) shaft (ы) and kardanny hinges
   7.4. Back and forward axes
   7.5. Bearing, epiploon and semi-axis of the back bridge
   7.6. Epiploon of a reducer of the back bridge and forward axis
   7.7. Zadny Bridge
   7.8. Forward semi-axes
   7.9. Replacement of covers and CV JOINT dismantling
   + 7.10. Electromagnetic drive of a forward leading axis (ADD system)
   7.11. Forward reducer
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electroschemes

7.2.5. The directing bearing

Check and replacement

PERFORMANCE ORDER

1. The directing bearing is a support of primary shaft of a check point and is pressed in an opening in a back flange of the crankshaft. A condition of the bearing it is necessary to check every time when coupling acts in film. If there are doubts concerning a bearing condition, it is necessary to replace it. At engine removal the bearing changes without fail.
2. Remove a transmission.
3. Remove coupling.
4. Check a bearing condition, having shined it in an opening.
	5. At detection of damages выпрессуйте the bearing.
	6. In the absence of a stripper remove the bearing by means of hydroblow. For this purpose fill deepening in the crankshaft with dense greasing, having carefully removed air, and strike on an opravka inserted into the bearing. Diameter of an opravka should be a little less internal diameter of the bearing. Get the bearing and remove all greasing.
	7. Press the new bearing. The epiploon of the bearing should be turned outside.
8. Establish coupling and a transmission.